溶剂型乙基硅酸锌底漆.doc

1、溶剂型乙基硅酸锌底漆Intended Uses用途溶剂型乙基硅酸锌底漆作为水性漆配套的底漆，用于轻度至严重腐蚀环境下的钢结构表面，如船舶、集装箱、海上平台、码头等海洋设施、石油化工管道与储罐、冶金、电力等行业中钢铁构件的防锈与防腐。As a water-miscible primer, it is widely used for the surface of steel structure, for example, it is widely used for ship, container the platform of the sea , wharf and the oil tubing

2、system, oil tank as metallurgy ,Electric power, etc steel structure as the anticorrosive coat. ProductDescription产品简介灰色无光，水性三组份环氧富锌底漆，采用鳞片状锌粉，干膜含量大于 80%，可能形成坚韧的防锈漆膜，对局部被损部位，可提供良好的阴极保护。以水为分散介质，不然不爆，可用水稀释和清洗涂装用具，施工过程无污染，具有安全环保特性。Grey, dark, three packages water-miscible epoxy zinc primer, it is contai

3、ning scale-like zinc powder, the coating of zinc in the film is more than 80%, it can be made into a firm and persistent film, it can protect the site which is broken.It is dispersed by water. Resist fire and burst, can be diluted or cleaned by water, No pollution, safety and environmental protectio

4、n.Volume Solids 固体份 60%Dry Film Thickness 干膜厚度70 microns equivalent to117 microns of wet film70 微米相当于 117 微米湿膜厚Theoretical Coverage 理论涂布率 3.01 m2 /Kg 3.01 平方米/公斤Practical Coverage 实际涂布率 Allow appropriate loss 允许适量损耗ProductInformation产品数据VOC 挥发性有机化合物含量 10g/L 10 克/升Mix Radio 混合比A : B： C=4:1:24(WT)甲（漆料

5、）:乙（固化剂）: 丙（锌粉）=4:1： 24Application Details施工详述Method of Application 施工方法Airless Spray 无空气喷涂 Recommended 推荐采用Brush or Roller 涂刷或辊涂 Recommended 推荐采用Conventional Spray 传统喷涂 Not Recommended 不推荐采用 Thinner 稀释剂 清洁淡水(Clean water)Cleaner 油漆设备清洗剂 清洁淡水(Clean water)Pot Life 使用期 20-3h (小时) Storage 贮存期 One year 一

6、年Over coating Interval覆涂间隔SubstrateTemperature底材温度,Touch Dry表干（min）Hard Dry硬干(H） Mix 最短 Max 最长 Drying time 干燥时间25 30 12 3h Not limit 不限 Storage 贮存 Store in cool and dry conditions (5-40) 贮存于 5-40 de 阴凉干燥处 Pack size 包装规格 A;20Kg in 20 liter container 甲:20 公斤装于 20 公升容器中B:5Kg in 5liter container 乙:5 公斤装

7、于 5 公升容器中C:50Kg in 20 liter container 丙:50 公斤装于 20 公升容器中Storage andHandling贮存与管理Specific Gravity 比重 Approx 2.85Kg/L 大约 2.85 公斤/公升Specification and Surface preparation技术要求及表面处理Clean and remove grease with proper solvents, Blast clean to Swedish Standard Sa2.5 or rust removed with power tool to St3, t

8、he roughness is 40-70 micronsBecause the edge and quarter is easy to be rust in regard to water miscible paint, the edge and the quarter must be smoothed and painted in advance.溶剂型乙基硅酸锌底漆用适当的清洁剂清除油脂，喷砂至 Sa2.5 级或动力工具除锈达 St3，粗糙度 40-70 微米，并保持表面清洁干燥。由于水性涂料，很容易从尖锐边角流开形成“边角效应 ”，为保护边角免遭腐蚀，需磨平边角，并预涂。Please

9、mix and stir still to even before application, during the application, the Limitations限制temperature of the environment should be above 10,the relative humidity should be less then 80%, the substrate temperature should be more than 3 above the dew point, enough ventilation is necessary at the applica

10、tion site.No application when the temperature is too low during night, No application when it is raining or there is dew the next coatings: water-miscible M.I.O. epoxy anti-corrosive paint, water-miscible epoxy finish, water-miscible acrylic paint etc; or some other solvent-based paints which are pe

11、rmitted, but the over coating interval time should be lengthened.The durability of the water-miscible paint is decided by the condition of the application, For example, on the edge and quarter, the application need be handled carefully, avoiding the film thickness is too thick once 溶剂型乙基硅酸锌底漆施工及干燥期间

12、，环境温度最好在 10以上相对湿度低于 80%，底材温度应高于露点 3以上，并保证良好的通风。避免在夜晚温度较低尤其是兼有凝露或雨水的季节户外施工。后道涂层：水性环氧云铁防锈漆、水性环氧面漆、水性丙烯酸漆等；也可覆涂溶剂型涂料，但最短涂覆间隔应延长。The product must be used in painting area by professionals. When painting, please be sure to refer to Product Data Sheet and MSDS. Consult our company if consumers could not c

13、ompletely understand the precautions for safety and health when applying the product.The product is a kind of solvent-based paint. In order to avoid the accident or dangerous occurrence, minimal safety precaution, as follow, should be down.The paint contains volatile solvent and it is flammable, So

14、must keep away from sparks and open flames. No smoking at workplace, Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid product sparks. Enough ventilation is necessary at applicatio

15、n sites. In order to remove any danger of explosion, must keep the ratio of gas / air is less than 10 %, Usually 200 m3of ventilation quantity per 1 Kg solvent (according to the solvent) is necessary, it canMaintain the minimum explosive limit. Take effective precautions to prevent skin and eye cont

16、act with the coating (such as the use of overalls, gloves, goggles, face shields and protective oil coating and so on). If paint gets in touch with skin,If accidental skin contact with the product, please use fresh water and soap or an appropriate industrial cleaning agents thoroughly cleansed. In c

17、ase of eyes being contaminated, rinse with fresh water for 10 min at least and give medical treatment SafetyPrecautions安全措施immediately.During painting, it is recommended to wear face shields to prevent inhalation of paint mist and harmful gases.Especially in poorly ventilated environment, it is more

18、 necessary.Finally, be handled with care so as not to waste paint barrels of pollution of the environment.NOTICE: If consumers have not taken effective safety precautions (Refer to the specification), our company will NOT be responsible for any accident.溶剂型乙基硅酸锌底漆必须由专业人员在工业场所使用。使用时请务必参照本说明书以及相关健康安全手

19、册。若客户在使用本产品前,未能详细了解本产品的相关健康安全知识,请与本公司人员联系。该涂料为溶剂型涂料，为避免事故或危险发生，应采取最低限度的安全措施如下：此涂料为易燃物,并含有挥发性易燃溶剂，故必须远离火星和明火。严禁在作业场所吸烟，并应该采取有效措施，防止火星产生(如采用防爆电器设备，杜绝静电积累,避免金属撞击等)。施工场所应尽量保持良好通风。为消除使用过程中的爆炸隐患,应保证足够的通风量以维持气体/空气比例不超过最低爆炸极限的 10 %,通常每千克溶剂需要 200 立方米通风量,(与溶剂种类相关)就能维持最低爆炸极限 10 %的工作环境。采取有效措施，防止皮肤和眼睛与涂料直接接触(如使用工作服,手套,护目镜,面罩及涂防护油等)。若皮肤不慎与产品相接触,请用清水及肥皂或适当的工业清洁剂彻底清洗；若眼睛受到污染,请即刻用清水冲洗至少 10 分钟,并立即就医。在施工时，建议佩戴面罩以免吸入漆雾和有害气体，尤其在通风不良的环境下，更要注意。最后请谨慎处理废旧漆桶以免污染环境。责任声明：对于未按本公司所要求采取有效得安全措施而引起的安全事故,本公司不负任何责任。来源 江苏纽克莱涂料有限公司 http:/www.nsk-