1、 2006 Cisco Systems, Inc. All rights reserved. Cisco ConfidentialPresentation_ID 1思科无线控制器配置基础 2006 Cisco Systems, Inc. All rights reserved. Cisco ConfidentialPresentation_ID 2Controller Initial Setup Options Serial Console Port Available on all models Male DB-9 pin connectorSupports pins 2,3&5Defaul
2、t port configuration9600 baud8 data bits1 stop bitNo parityNo hardware flow control DB-9 female to female null-modem serial cable Dedicated to AireOS managementEnsures access to AireOS in the event of a network failureCan be used for initial installationAccess to CLI only Service Interface Port Not
3、available on all modelsOnly on 4XXX series 10/100Base-TX Ethernet port which is speed auto-sensing Service Interface Port is not auto-sensing for DTE / DCEStraight-through ethernet cable to controller or hub Crossover ethernet cable to end station or router Category 5 Ethernet cable Dedicated to Air
4、eOS managementEnsures access to AireOS in the event of a network failureCan be used for initial configuration or OOB management from management networkHas a default 192.168.1.1/24 default IP address 2006 Cisco Systems, Inc. All rights reserved. Cisco ConfidentialPresentation_ID 3Boot OptionsThe cont
5、roller boot sequence will always have these option available since this is set in PROM to ensure controller recovery options 2006 Cisco Systems, Inc. All rights reserved. Cisco ConfidentialPresentation_ID 4Run Primary or Backup ImageIf no escape key is hit to halt the boot process and to enter the b
6、oot options menu, the boot process will begin automaticallyCisco Airespace AireOS VersionBootloader: Not found only after initial controller boot or controller upgrade 2006 Cisco Systems, Inc. All rights reserved. Cisco ConfidentialPresentation_ID 5Run Primary or Backup Image (continued)AP will not
7、light up until Starting Power Over Ethernet Services: okWeb Authentication Certificate not found (error) only after initial controller boot or controller upgradeCisco Airespace Wizard Configuration Tool begins automatically if no saved configuration 2006 Cisco Systems, Inc. All rights reserved. Cisc
8、o ConfidentialPresentation_ID 6Controller Configuration Single binary configuration fileImportant to perform configuration backupsNo text outputShow running configuration is a summary configuration not in command syntaxContains no MAC address informationCan be ported to multiple Cisco Airespace Cont
9、rollersBeware of duplicate IP addresses Controller has two configurationsRunning-configurationAny commands take effect immediately and are only part of the running-configuration until a save configuration command is issuedIf not saved, commands will be lost in the case of a reset without a save conf
10、iguration or a power cycleSaved-configurationConfiguration saved in NVRAM after performing save configuration command 2006 Cisco Systems, Inc. All rights reserved. Cisco ConfidentialPresentation_ID 7CLI Wizard Configuration Tool 2006 Cisco Systems, Inc. All rights reserved. Cisco ConfidentialPresent
11、ation_ID 8CLI Wizard Configuration Tool (continued) 2006 Cisco Systems, Inc. All rights reserved. Cisco ConfidentialPresentation_ID 9Command Line Interface (CLI)Basic Command Set 2006 Cisco Systems, Inc. All rights reserved. Cisco ConfidentialPresentation_ID 10Command Line Interface (CLI)“clear” Commands
