1、 Product Name: MOBIL VACTRA OIL NO. 2 Revision Date: 29 Jun 2012 Page 1 of 11 _ SAFETY DATA SHEET SECTION 1 PRODUCT AND COMPANY IDENTIFICATION PRODUCT Product Name: MOBIL VACTRA OIL NO. 2 Product Description: Base Oil and Additives Product Code: 201560901015, 600494 Recommended Use: Lubricant COMPAN
2、Y IDENTIFICATION Supplier: ExxonMobil (China) Investment Co., Ltd. 17/F., Metro Tower 30 Tian Yao Qiao Road Shanghai 200030 China 24 Hour Environmental / Health Emergency Telephone (+86) 0532-83889090 (NRCC) Supplier General Contact (+86) 021-24076000 SECTION 2 HAZARDS IDENTIFICATION This material i
3、s not hazardous according to regulatory guidelines (see (M)SDS Section 15). Contains: PHOSPHORIC ACID ESTERS, AMINE SALT May produce an allergic reaction. Other hazard information: PHYSICAL / CHEMICAL HAZARDS No significant hazards. HEALTH HAZARDS High-pressure injection under skin may cause serious
4、 damage. Excessive exposure may result in eye, skin, or respiratory irritation. ENVIRONMENTAL HAZARDS No significant hazards. Product Name: MOBIL VACTRA OIL NO. 2 Revision Date: 29 Jun 2012 Page 2 of 11 _ NOTE: This material should not be used for any other purpose than the intended use in Section 1
5、 without expert advice. Health studies have shown that chemical exposure may cause potential human health risks which may vary from person to person. SECTION 3 COMPOSITION / INFORMATION ON INGREDIENTS This material is defined as a mixture. Hazardous Substance(s) or Complex Substance(s) required for
6、disclosure Name CAS# Concentration* GHS Hazard Codes PHOSPHORIC ACID ESTERS, AMINE SALT 91745-46-9 0.1 - 1% H226, H302, H317, H318, H401, H411 * All concentrations are percent by weight unless ingredient is a gas. Gas concentrations are in percent by volume. SECTION 4 FIRST AID MEASURES INHALATION R
7、emove from further exposure. For those providing assistance, avoid exposure to yourself or others. Use adequate respiratory protection. If respiratory irritation, dizziness, nausea, or unconsciousness occurs, seek immediate medical assistance. If breathing has stopped, assist ventilation with a mech
8、anical device or use mouth-to-mouth resuscitation. SKIN CONTACT Wash contact areas with soap and water. If product is injected into or under the skin, or into any part of the body, regardless of the appearance of the wound or its size, the individual should be evaluated immediately by a physician as
9、 a surgical emergency. Even though initial symptoms from high pressure injection may be minimal or absent, early surgical treatment within the first few hours may significantly reduce the ultimate extent of injury. EYE CONTACT Flush thoroughly with water. If irritation occurs, get medical assistance
10、. INGESTION First aid is normally not required. Seek medical attention if discomfort occurs. SECTION 5 FIRE FIGHTING MEASURES EXTINGUISHING MEDIA Product Name: MOBIL VACTRA OIL NO. 2 Revision Date: 29 Jun 2012 Page 3 of 11 _ Appropriate Extinguishing Media: Use water fog, foam, dry chemical or carbo
11、n dioxide (CO2) to extinguish flames. Inappropriate Extinguishing Media: Straight streams of water FIRE FIGHTING Fire Fighting Instructions: Evacuate area. Prevent run-off from fire control or dilution from entering streams, sewers or drinking water supply. Fire-fighters should use standard protecti
12、ve equipment and in enclosed spaces, self-contained breathing apparatus (SCBA). Use water spray to cool fire exposed surfaces and to protect personnel. Hazardous Combustion Products: Smoke, Fume, Aldehydes, Sulphur oxides, Incomplete combustion products, Oxides of carbon FLAMMABILITY PROPERTIES Flas
13、h Point Method: 205C (401F) ASTM D-92 Flammable Limits (Approximate volume % in air): LEL: 0.9 UEL: 7.0 Autoignition Temperature: N/D SECTION 6 ACCIDENTAL RELEASE MEASURES NOTIFICATION PROCEDURES In the event of a spill or accidental release, notify relevant authorities in accordance with all applic
14、able regulations. PROTECTIVE MEASURES Avoid contact with spilled material. See Section 5 for fire fighting information. See the Hazard Identification Section for Significant Hazards. See Section 4 for First Aid Advice. See Section 8 for advice on the minimum requirements for personal protective equi
15、pment. Additional protective measures may be necessary, depending on the specific circumstances and/or the expert judgment of the emergency responders. For emergency responders: Respiratory protection: respiratory protection will be necessary only in special cases, e.g., formation of mists. Half-fac
16、e or full-face respirator with filter(s) for dust/organic vapor or Self Contained Breathing Apparatus (SCBA) can be used depending on the size of spill and potential level of exposure. If the exposure cannot be completely characterized or an oxygen deficient atmosphere is possible or anticipated, SC
17、BA is recommended. Work gloves that are resistant to hydrocarbons are recommended. Gloves made of polyvinyl acetate (PVA) are not water-resistant and are not suitable for emergency use. Chemical goggles are recommended if splashes or contact with eyes is possible. Small spills: normal antistatic wor
18、k clothes are usually adequate. Large spills: full body suit of chemical resistant, antistatic material is recommended. SPILL MANAGEMENT Land Spill: Stop leak if you can do so without risk. Recover by pumping or with suitable absorbent. Water Spill: Stop leak if you can do so without risk. Confine t
19、he spill immediately with booms. Warn Product Name: MOBIL VACTRA OIL NO. 2 Revision Date: 29 Jun 2012 Page 4 of 11 _ other shipping. Remove from the surface by skimming or with suitable absorbents. Seek the advice of a specialist before using dispersants. Water spill and land spill recommendations a
20、re based on the most likely spill scenario for this material; however, geographic conditions, wind, temperature, (and in the case of a water spill) wave and current direction and speed may greatly influence the appropriate action to be taken. For this reason, local experts should be consulted. Note:
21、 Local regulations may prescribe or limit action to be taken. ENVIRONMENTAL PRECAUTIONS Large Spills: Dike far ahead of liquid spill for later recovery and disposal. Prevent entry into waterways, sewers, basements or confined areas. SECTION 7 HANDLING AND STORAGE HANDLING Prevent small spills and le
22、akage to avoid slip hazard. Material can accumulate static charges which may cause an electrical spark (ignition source). When the material is handled in bulk, an electrical spark could ignite any flammable vapors from liquids or residues that may be present (e.g., during switch-loading operations).
23、 Use proper bonding and/or earthing procedures. However, bonding and earthing may not eliminate the hazard from static accumulation. Consult local applicable standards for guidance. Additional references include American Petroleum Institute 2003 (Protection Against Ignitions Arising out of Static, L
24、ightning and Stray Currents) or National Fire Protection Agency 77 (Recommended Practice on Static Electricity) or CENELEC CLC/TR 50404 (Electrostatics - Code of practice for the avoidance of hazards due to static electricity). Static Accumulator: This material is a static accumulator. STORAGE The c
25、ontainer choice, for example storage vessel, may effect static accumulation and dissipation. Do not store in open or unlabelled containers. SECTION 8 EXPOSURE CONTROLS / PERSONAL PROTECTION Exposure limits/standards for materials that can be formed when handling this product: When mists / aerosols c
26、an occur, the following are recommended: 5 mg/m3 - ACGIH TLV (inhalable fraction). Biological limits No biological limits allocated. Product Name: MOBIL VACTRA OIL NO. 2 Revision Date: 29 Jun 2012 Page 5 of 11 _ NOTE: Limits/standards shown for guidance only. Follow applicable regulations. ENGINEERI
27、NG CONTROLS The level of protection and types of controls necessary will vary depending upon potential exposure conditions. Control measures to consider: No special requirements under ordinary conditions of use and with adequate ventilation. PERSONAL PROTECTION Personal protective equipment selectio
28、ns vary based on potential exposure conditions such as applications, handling practices, concentration and ventilation. Information on the selection of protective equipment for use with this material, as provided below, is based upon intended, normal usage. Respiratory Protection: If engineering con
29、trols do not maintain airborne contaminant concentrations at a level which is adequate to protect worker health, an approved respirator may be appropriate. Respirator selection, use, and maintenance must be in accordance with regulatory requirements, if applicable. Types of respirators to be conside
30、red for this material include: No special requirements under ordinary conditions of use and with adequate ventilation. Particulate filter when appropriate. For high airborne concentrations, use an approved supplied-air respirator, operated in positive pressure mode. Supplied air respirators with an
31、escape bottle may be appropriate when oxygen levels are inadequate, gas/vapour warning properties are poor, or if air purifying filter capacity/rating may be exceeded. Hand Protection: Any specific glove information provided is based on published literature and glove manufacturer data. Glove suitabi
32、lity and breakthrough time will differ depending on the specific use conditions. Contact the glove manufacturer for specific advice on glove selection and breakthrough times for your use conditions. Inspect and replace worn or damaged gloves. The types of gloves to be considered for this material in
33、clude: No protection is ordinarily required under normal conditions of use. Nitrile Eye Protection: If contact is likely, safety glasses with side shields are recommended. Skin and Body Protection: Any specific clothing information provided is based on published literature or manufacturer data. The
34、types of clothing to be considered for this material include: No skin protection is ordinarily required under normal conditions of use. In accordance with good industrial hygiene practices, precautions should be taken to avoid skin contact. Specific Hygiene Measures: Always observe good personal hyg
35、iene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. Discard contaminated clothing and footwear that cannot be cleaned. Practice good housekeeping. Product Name: MOBIL VAC
36、TRA OIL NO. 2 Revision Date: 29 Jun 2012 Page 6 of 11 _ ENVIRONMENTAL CONTROLS Comply with applicable environmental regulations limiting discharge to air, water and soil. Protect the environment by applying appropriate control measures to prevent or limit emissions. SECTION 9 PHYSICAL AND CHEMICAL P
37、ROPERTIES Note: Physical and chemical properties are provided for safety, health and environmental considerations only and may not fully represent product specifications. Contact the Supplier for additional information. GENERAL INFORMATION Physical State: Liquid Colour: Amber Odour: Characteristic O
38、dour Threshold: N/D IMPORTANT HEALTH, SAFETY, AND ENVIRONMENTAL INFORMATION Relative Density (at 15 C): 0.883 Flash Point Method: 205C (401F) ASTM D-92 Flammable Limits (Approximate volume % in air): LEL: 0.9 UEL: 7.0 Flammability (Solid, Gas): N/A Autoignition Temperature: N/D Boiling Point / Range
39、: 316C (600F) Vapour Density (Air = 1): 2 at 101 kPa Vapour Pressure: 3.5 Solubility in Water: Negligible Viscosity: 68 cSt (68 mm2/sec) at 40 C | 8.6 cSt (8.6 mm2/sec) at 100C Freezing Point: N/D Melting Point: N/A Decomposition Temperature: N/D Oxidizing Properties: See Hazards Identification Sect
40、ion. OTHER INFORMATION Pour Point: -6C (21F) DMSO Extract (mineral oil only), IP-346: 5000 mg/m3 Minimally Toxic. Based on test data for structurally similar materials. Irritation: No end point data for material. Negligible hazard at ambient/normal handling temperatures. Based on assessment of the c
41、omponents. Ingestion Toxicity (Rat): LD50 5000 mg/kg Minimally Toxic. Based on test data for structurally similar materials. Skin Toxicity (Rabbit): LD50 5000 mg/kg Minimally Toxic. Based on test data for structurally similar materials. Irritation (Rabbit): Data available. Negligible irritation to s
42、kin at ambient temperatures. Based on test data for structurally similar materials. Eye Irritation (Rabbit): Data available. May cause mild, short-lasting discomfort to eyes. Based on test data for structurally similar materials. OTHER HEALTH EFFECTS FROM SHORT AND LONG TERM EXPOSURE Anticipated hea
43、lth effects from sub-chronic, chronic, respiratory or skin sensitization, mutagenicity, reproductive toxicity, carcinogenicity, target organ toxicity (single exposure or repeated exposure), aspiration toxicity and other effects based on human experience and/or experimental data. Contains: Base oil s
44、everely refined: Not carcinogenic in animal studies. Representative material passes IP-346, Modified Ames test, and/or other screening tests. Dermal and inhalation studies showed minimal effects; lung non-specific infiltration of immune cells, oil deposition and minimal granuloma formation. Not sens
45、itising in test animals. Additional information is available by request. The following ingredients are cited on the lists below: None. Product Name: MOBIL VACTRA OIL NO. 2 Revision Date: 29 Jun 2012 Page 8 of 11 _ -REGULATORY LISTS SEARCHED- 1 = NTP CARC 3 = IARC 1 5 = IARC 2B 2 = NTP SUS 4 = IARC 2
46、A 6 = OSHA CARC SECTION 12 ECOLOGICAL INFORMATION The information given is based on data available for the material, the components of the material, and similar materials. ECOTOXICITY Material - Not expected to be harmful to aquatic organisms. MOBILITY Base oil component - Low solubility and floats and is expected to migrate from water to the land. Expected to partition to se
