1、Magnetic Stirrer磁力搅拌器User Manual说明书请在使用前仔细阅读本说明书，并且遵守所有操作安全提示！Contents 内容Contents 内容.1Preface 前言.2Warranty 质保期.21. Safety Instructions 安全提示.32. Proper Use 适用范围.33. Inspection 检查.63.1 Receiving Inspection 验收 .63.2 Listing of Items 零件清单.64. Trial run 调试 .75. Control and Display 控制及显示.75.1 Control elem
2、ents 控制器 .75.2 Display 显示 .86. Operating Modes 操作示例.86.1 Magnetic stirrer with hot plate operation 磁力搅拌器操作说明（不带加热板）.86.2 Hot Plate without stirring operation 电热板操作说明（不带搅拌器）.96.3 Digital type operation 数显型操作说明 .97. Faults 错误.128. Maintenance and Cleaning 保养及清洁维护.139. Storage and transportation 存放及运输.
3、1310. Main technical parameters 主要技术参数.1411. Working condition 工作条件.14-1-Preface前言Thank you for purchasing our products: Hotplate / Magnetic Stirrer. Users should read this Manual carefully, follow the instructions and procedures, and beware of all the cautions when using this instrument.感谢您购买我们的产品：
4、电热板/磁力搅拌器。使用者需要仔细阅读该说明书根据提示操作本产品呢，并且在操作过程中注意所有注意事项。Connect the device to an earthed power supply to ensure safety of machine and experiment; connect the power as the machine required.必须接地以保证产品和实验的安全。按产品要求连接电源。This equipment is forbid to use in inflammable and explosive, poisonous and strong corrosiv
5、e experiments.本产品禁止用于易燃易爆，有毒及强腐蚀性实验。Make sure horizontal installation.确保产品水平放置。Non-professionals are not allowed to disassemble and repair this machine.禁止非专业人员拆卸并修理本产品。Pay attention to the set temperature while dealing with the inflammable matters.当处理易燃物时，请注意小心设置温度。Make sure dry the resin container,
6、 if the temperature is setting too high by accident, the container would be dissolved and then fall on the heater to cause fire.当不小心操作温度过高时，请注意树脂容器因温度过高而融化并且导致起火。Overfilled of sample will lead to overheat of working room under parts, which will dissolve the inflammable material and cause fire.切勿装样品过
7、满而导致溶解物溢出，因为容易使溶解样品进入加热盘底部工作室内从而导致易燃零件起火。While the machine is working, dont touch the top, window and exhaust port of the device to protect from high-temperature burns.当机器工作时，切勿触摸加热盘，窗口及排风口以放置超温起火。Read the instruction book before operation.在操作前请仔细阅读本说明书。Warranty 保修期This instrument is warranted to be
8、 free from defects in materials and workmanship under normal use and service, for a period of 12 months from the date of invoice. The warranty is extended only to the original purchaser. It shall not apply to any product or parts which have been damaged on account of improper installation, improper
9、connections, misuse, accident or abnormal conditions of operation.For claim under the warranty please contact with us. You many also send the instrument direct to our works or we send you the spare parts to help you resolve this problem in next order, enclosing the invoice copy and by giving reasons
10、 for the claim. You would be solely liable for freight costs.本产品在保修期为自售出日期开始后 12 个月。保修期仅适用于最初采购商。因进口商不正当安装，不正确连接，或者错误使用而导致产品损坏不在保修范围内。1 Safety Instructions 安全提示 When working, ware the personal guard to avoid the risk from: 当使用时，请注意人身安全以避免以下危险：- Splashing and evaporation of liquids- Release of toxic
11、or combustible gases.- 液体的喷溅及蒸发- 有毒气体及可燃气体的释放。 Set up the instrument in a spacious area on an stable, clean, non-slip, dry and fireproof surface, do not operate the instrument in explosive atmospheres, with hazardous substances or under water. 请把产品安装在开阔，稳定，干净，防滑，干燥并且防火的地方。不能在易燃易爆，危险物品及潮湿环境下使用。 Gradu
12、ally increase the speed, reduce the speed if: 请慢慢的调节速度当：- The stirring bar breakaway because of too high speed - The instrument is not running smoothly, or container moves on the base plate.- 搅拌子因为速度过快而跳动或者不转动。- 产品运行不流畅或者容器移动至板面边缘。 Beware of hazards due to: 当操作时注意危险：- Flammable material or media wit
13、h a low boiling temperature- Overfilling of media- Unsafe container- 易燃材料或者低沸点材料- 样品过满- 不安全的容器 Process pathogenic materials only in closed vessels. 如果是致病材料，请将其置于密闭容器中。 If the case of the stirrer bar is PTFE, plate note: 当搅拌子是 PTFE 材质时，请注意：Elemental fluorine, three fluoride and alkali metals will cor
14、rode the PTFE and Halogen alkenes make it expansion at room temperature Molten alkali, alkaline earth metals or their solution, as well as the power in second and third ethnic of the Periodic Table of elements will have chemical reaction with PTFE when temperature reaches 300 400 氟元素，三氯化物及碱金属会腐蚀 PTF
15、E 材料。在室温条件下卤素和烯烃会使其膨胀膨胀 。 碱金属或其他元素周期表中第二及第三周期的元素会和 PEFE 材料发生化学反应，当温度达到 300 400 时。Check the instrument and accessories before hand for damage each time you use them.每次使用前，请检查产品及配件是否完好以防止造成伤害。Do not use damaged components. Safe operation is only guaranteed with the accessories described in the “Access
16、ories” chapter. Accessories must be securely attached to the device and cannot come off by themselves. Always disconnect the plug before fitting accessories.不要用已损坏的配件。配件必须完好的连接到机器上并且不能自动脱落。在安装配件时请拔掉电源。 Ensure that the external temperature sensor is inserted in the media to a depth of at least 20mm.
17、确保外部温度传感器插入实验样品里最少 20mm。 When using metal vessels, do not place the temperature sensors on the bottom of the vessel. 当用金属容器时，不要将温度传感器放在金属容器底部。Placing sensors on the vessel bottom can cause excessively high temperature to be measured especially in media which have poor conductivity. The tip of the me
18、asuring sensor must be at least 5mm from the vessel bottom, a distance of 10mm is ideal.当将传感器置于容器底部时，会导致被测量温度极大的升高，尤其是试验样品导电性低的时候。传感器头部必须离容器底部 5mm,10mm 是最理想的距离。 The instrument can only be disconnected from the main power supply by pulling out the mains plug or the connector plug. 必须在拔掉主电源插头或者连接器插头时才
19、可以拔掉仪器电源。 The voltage stated on the label must correspond to the main power supply. 产品使用电压必须要和主电源电压一致. Ensure that the mains power supply cable does not touch the heating base plate. Do not cover the device. 确保主电源线不碰触产品加热元件，并且电源线不能缠绕仪器。 Keep away from high magnetic field. 远离强磁区域。 Observe the minimum
20、 distances between the devices, between the device and the wall and above the assembly (min.100mm). 产品离墙体距离最少 100mm.Figure 1-5-2 Proper Uses适用范围The instrument is designed for mixing and / or heating liquids in schools, laboratories or factories. This device is not suitable for using in residential a
21、reas or other constraints mentioned in Chapter 1.本产品适用于学校，实验室及工厂的液体搅拌 和/或 加热实验。本产品不适用于居民区或者其他 1 章内有约束条件的环境下。3 Inspections检验3.1 Receiving Inspection3.1 验收Unpack the equipment carefully and check for any damages which may have arisen during transport. If it happens, please contact manufacturer for tec
22、hnical support.小心的打开仪器包装并且检查是否在运输过程中产品有被损坏 。如果损坏，请联系工厂的技术支持部门。Note: 注意：If there is any apparent damage to the system, Please do not plug it into the power line.如果有任何损坏，请不要将产品连接电源。3.2 Listing of Items 零件清单The packing includes the following items:箱内有如下货物：With Magnetic Stirrer 带磁力搅拌器的 Without Magnetic
23、Stirrer机体 1 机体 1电源线 1 电源线 1搅拌子 1 说明书 1说明书 1 架杆 1架杆 1 保险丝 1保险丝 1Table 2 Table 3Please check the instrument and appendix with the packing list when you first open the instrument packing case. If you find there is something wrong with the instrument and the appendix, do contact the vendor or the produc
24、er.当您第一次打开产品箱子的时候，请根据配件清单核对产品及配件是否一致。如果有问题，请联系代理商或者工厂。4 Trial Runs调试 Make sure the required operating voltage and power supply voltage match. 确定电源电压和产品要求电压一致。 Ensure the socket must be earthed reliably. 确保电源插座必须接地。 Ensure the power be off 确定电源是关闭的。 Plug in the power cable, ensure the power be on and
25、 begin initializing. 插入电源，确定电源打开。 Add the medium into the vessel with a stirring bar if with the magnetic stirrer function. 加入待实验样品至容器内。如果是带搅拌器的，把搅拌子放进去。 Put the vessel on the work plate. 把容器放在加热板面上。 Set the rated stirring speed and start stirring. 设定搅拌速度并开始搅拌。 Observe the stirring bar and LCD displ
26、ay. 观察搅拌子及 LCD 显示屏。 Set the rated temperature and start heating. 观察额定温度并且开始加热。 Observe the real temperature on LCD display. 观察 LCD 显示屏上的实际被测温度。 Stop the heating and stirring functions. 停止加热和搅拌功能。If these operations above are normal, the device is ready to operate. If these operations are not normal,
27、 the device may be damaged during transportation, please contact manufacture for technical support.如果以上操作正常，则此产品可以进行使用。如果有不正常的地方，则产品在运输过程中损坏，请联系制造商以获取技术支持。5 Control PanelFigure 2Figure 3 Figure 46 Operating Modes 操作示例6.1 Magnetic stirrer with hot plate operation:磁力搅拌器（带加热） Place the equipment on lev
28、el worktable, and then put the container with liquid one the hotplate. 将产品置于水平工作台上，并把盛有液体的容器置于加热板上。 Switch on the power accords with the machine, then power indicator light will be lighten; turn on the power of regulation knob, and turn the knob clockwise, then the working indicator light will be li
29、ghten; in the process of regulating, the light intensity changes according to different regulation position, and the temperature rises as well. 打开电源，电源指示灯亮，顺时针调节电源旋钮，工作指示灯亮，在调节过程中，指示灯亮度会根据调节旋钮的移动而改变，同时温度上升。Notes: Adjust the speech slowly, please adjust the speech when the appear the follows conditio
30、n: 慢慢调节速度，当出现如下情况是请调节速度。a. Too high speech makes the stir breakaway.速度过快而使搅拌子不工作。The equipment appears move on the heating plate.容器在加热板上移动。 The power must accord with the machine.电源必须同机器要求电源相符。 Make sure the power line has safety distance from the heating plate. 确保电源线和加热板距离足够安全。 When the machine mee
31、ts fault, please cut off the Electricity first. 关掉电源当机器出现故障时。Main technical parameters 主要技术参数型号 电压 (V) 转速r.p.m 加热 功率 最大容积(ml) 最大温度. (plate)电热板尺寸(mm)SH-2A - 180 - 380SH-2B - -SH-21002000 180 1000 380120120SH-3A - 500 - 380SH-3B - -SH-31002000 500 2000 380170170SH-4A - 600 - 380SH-4B - -SH-4 380SH-4C1002000 600 500035010%190190SH-5A - 1200 - 350 300x300SH-6A - 1800 - 350 350x450SH-7A - 2000 - 350 400x400SH-8A - 2800 - 350 350x600SH-9A220V/50HzOr 11V/60Hz- 3000 - 350 400x600
